The original design for this motor should be credited to John Bedini and Ron Cole. John Bedini is recognized today as an electrical/electronic. The article following is a brief account of my construction and testing of the Bedini /Cole window motor. It is a work in progress and thus may. Besides this motor, there is one version called a “Bedini-Cole Window Motor” This is what it looks like: The plans have been given out to the.
|Published (Last):||4 May 2005|
|PDF File Size:||12.86 Mb|
|ePub File Size:||9.35 Mb|
|Price:||Free* [*Free Regsitration Required]|
This motor does not produce any great output power as it spins, and yet it is an important device because it can run indefinitely without needing a battery to power it. Instead of a battery, the motor uses a capacitor. Initially, the capacitor is discharged fully, showing that the device is definitely at a minimum power level. The motor is then given a gentle spin, from which it develops its own power and accelerates to its normal operating speed. The fact that it accelerates from the initial spin rate, demonstrates that the power is not coming from the starting energy.
This device is a perpetual-motion machineand that is a major problem for conventional science of today, which fondly imagines that perpetual motion is impossible. No calculations with their assumptions and possibilities for error, are needed for this motor.
There is no external input powerand yet the device produces motion, sound, heat, mechanical wear and in addition, it generates increasing charge on the capacitor.
That charge could be taken off to charge a battery, but this is not done so that there is no possibility of people thinking that the battery being charged is actually powering the device. In this circuit drawing, the option is given for either battery charging or operating from a capacitor.
We are interested primarily in the capacitor version as it demonstrates very clearly that conventional science needs to be revised to encompass both perpetual motion and the Zero-Point Energy field which provides the power for what we see as perpetual motion:. Several variations for this design are possible. John shows the timing for the pulses taken directly from a commutator where sliding contacts move across a copper strip on the shaft of the motor. The version shown in the video of this motor running, uses a Hall-effect semiconductor to sense the position of the shaft magnetically and utilises solid-state relays to do the switching.
The bi-filar coil is wound with thin wire being used for the signal drive to the MPS timing transistor. Bedini Cole Window Motor.
Sun Nov 19, 3: But if we do not have the space I will make an internet page. As to the drawing on my lab note I think you understand where the energy comes from. This takes time to see this in your mind, once you understand you can make any motor do this.
Take the window motor wind it like the SG when you connect it like the SG you will have better performance, since there is no iron you can use neo magnetswhen you see Ron Coles ybedini you will understand how to make three window coils. The impedance of this motor is very low, you want to start with a moderate impedance at first, say turns around the outside bi-filer.
What you will learn is that you can make this device many wayshbedkni many different circuits.
John Bedini Window Motor :: Nikola TESLA 3 generations later
I will only post this one time then I will take the page down after Rick gets all the information for the group. Sterling and Eric Kthey are doing everything possible to stop the book from coming out, I have seen the E-mails to Tom, and his crappie analysis of the ,otor project.
His omtor data proves that he did get it to work as I said to him in the beginning. The monopole experiment was to get you to understand the important part of hidden magnetic fields and switchingthe switching is the important part.
Without the correct switching you will never make it happenyou are a smart group and should figure this out right away. Be very careful they will come after you if you talk. Hide your machine in your mind and wait for the right time. When God says go Wnidow go, you should do the same. The Group wants a self runner with windo power outputso I posted everything Cole and I did to get everybody to understand how simple this can be done.
Example the Sweet device crossed coilsgenerator, motor coils. The charging of the capacitor and switching is the critical part. The reason I told the Lockridge story was to get everybody to understand the two independent coils, one set charges the capacitor the other is a motorone fired single pulse saving the extra pole South in the rotor for the generator.
The capacitor must be chosen for the correct value to gain energy as fast as possible as a normal generator using a full wave bridge rectifier.
You do not want to waste power in the motor function, MASS weight is important here for rotation. The Bi-polar switching allows for this to work with one power coil with the bridge connected across the motor coil as shown in the video.
What we are looking for is to self run the motor, and pull extra energy from the AC part of the generator to run lights or charge batteries, keeping the capacitor charged to run the motor.
Here is the real kicker.
Everyone please read this slowly and carefully. Bedini hand-spins his 6 pole armature, at first, the cap is empty we can safely assume this. After running it a few times, he stops the armature with hbedihi hand.
The armature restarts rotation without any intervention. The armature was spun by hand. It means the armature cannot have been spun to any high RPMs; it is physiologically impossible. With a motor like this, using a heavy flywheel for conservation of as much angular momentum as possible, it should be possible to periodically dump that capacitor to a battery or load a supercapacitor, which gives us a a NET GAIN in usable DC electrical energy.
Imagine what one might do if you had an outboard motor pull cord on that shaft to really get coel thing whizzing at the start. A kind of Gray Window Motor which runs on nearly pure potential and almost no current…. Carl you think I should find a dead battery to run it on and film it, think I will. Build it Carl, Build it, you can see it in your mind. Movie downloaded November 22 from, http: Message ofWed Nov 22, 2: If you move the fan alignment the fan will go through speed changes.
This is a all in one machine. Message ofThu Nov 23, 3: The Fan, The fan is connected though that long shaft. Notice that the fan bearings are in slotted groves if you angle the shaft the magnetic spins angle different causing the mohor to slow down, if you angel the other direction the fan speeds up. The shaft is through the center on bearings.
At the back of the shaft is a mass weight 1lb flywheel for rotation. The circuit powering this is the monopole circuit one pulse at a time. Modified Bedini Cole Window Motor http: Mike HMM from the gn0sis http: The motor does not run indefinitely.
The thought is that it might be made to with more robust components. For the sake of brevity, a package has been made with quite a few pictures and the video related to this: He has not considered all the factors! Mike says it does not run forever.
So far it has only stopped because of component voltage ratings were not high enough to handle the current generated by the device. It has never spun down to a dead stop.
The motor design presented is interesting, but, as its inventor claims, it is not over-unity. One piece of major evidence of its prowess is its ability to charge a 47,uF capacitor to 6 volts with hardly any change in its rotation rate. Let us consider some of the physics of this design, particularly a calculation of the energy required to charge the capacitor, and a rough estimation of the rotational energy of this motor.
Since neither materials, not dimensions, are presented on the website, I am only making a rough approximation for the latter based upon what I can estimate from the images.
The rotational energy of the motor is calculated at. Suppose that the motor rotates at rpm, which is 50 revolutions per second. I would figure that the diameter of the cylinder is about 3 inches or 0.
The rotational kinetic energy would then be: From this rough analysis, it is seen that the rotational kinetic energy is approximately times that of the capacitor charging energy. Thus, one would expect hardly any change in the apparent rotation rate of the armature due to the energy draw to the capacitor.
Bedini-Cole Window Motor Electric motor runs without draining batteries!!! – Energetic Forum
So it is a factor 10 less input energy already as Mr. Indeech calculated, and also its mass is probably much less than the guessed 2. So I guess the mass of the rotor is at maximum grams or less…. So already moor fact that the rotor accelerates in RPM while charging a cap and wiindow motor runs for hours and hours while not slowing down, while charging the cap higher and higher indeed [indicates] overunity.
This is the coel video documentation http: For the first time, from cold evidence, I believe there is something thereassuming the small details I cannot see are not energy sources. There is no way the hand twist start imparted any energy that was stored and released slowly to accelerate the rotor! As stated these drawings and machines have been on my internet sight since the internet started. The Window Motor is very moor to the many I have built over the years, however unless everybody has your exact detailswire size, lengths in feet, switching devices, exact circuit wiring and so on, they will never reproduce it.
The first thing to state here is that their is a big difference between efficiency and COP of the system. In the motor you reproduced your efficiency is around The next problem is that your hall device can not work correct, because of the Radiant spikeif you hberini away the Hall will soon burn hbedinj and that part will hinder your performance.
So I will state for the record right here the Motor section is not over unity and your statement is correct. The Group needs to understand what they are buildingthey are building a machine that takes advantage of a simple trigger system, you must supply the trigger to cause the effect to happen.
Sharp gradients cause normal EM systems to do real funny things since it is not in the normal text.
John Bedini Window Motor
For example the correct sharp pulse can trigger a battery to recharge itself, it can cause a capacitor to recharge itself and so on. You are dealing with quantum systems when you cause this to happen, and they look totally different from the standard EM systemswhen you combine the two you have real trouble. Normal Wimdow systems are designed to never be over unity and you only have meters and scopes that see only this, you can not see in the Quantum level with your instruments.
You Have made a great leap in what you did and posted to the internet in this group along with the Video.